1、用大量清水沖洗鋁板板表面，使用浸有經水稀釋過的洗滌劑，軟布輕輕的擦試板面，大量的清水沖洗板面將臟物沖走，檢查板面，對于沒有洗干凈的地方用洗滌劑核心清洗； 用清水沖洗板面，直至將洗滌劑全部沖掉。

1. Rinse the surface of the aluminum plate with a large amount of clean water, use a detergent diluted with water, and gently wipe the surface of the plate with a soft cloth. Rinse the plate surface with a large amount of clean water to remove dirt, inspect the plate surface, and focus on cleaning areas that have not been cleaned with detergent; Rinse the board surface with clean water until all the detergent is removed.

2、日常保養可以用清水擦拭，清潔時，使用大量清水稀釋洗潔精后進行擦拭。若頑固污漬無法清潔，再使用專門的鋁扣板清潔劑，清潔劑一定要用中性的，不能用咸性和酸性的，來進行深度的清潔，非常后都用清水擦拭通風晾干即可。

2. Daily maintenance can be done by wiping with clean water. When cleaning, use a large amount of diluted detergent with clean water before wiping. If stubborn stains cannot be cleaned, use a specialized aluminum buckle plate cleaner. The cleaner must be neutral, not salty or acidic, for deep cleaning. Finally, wipe with clean water and let it air dry.

3、深度清洗時應該分二遍進行，第一次用沾水的軟布擦洗，第二次再用洗潔精擦洗一下，也可以用清潔劑之類的專業清潔油脂、油跡和污垢的清潔劑，開窗通風自然干即可，如通風陽光不好，那么用質量比較好的紙巾擦一次即可。

3. When conducting deep cleaning, it should be done in two steps. The first step is to wipe with a soft cloth soaked in water, and the second step is to use detergent to clean it again. Professional cleaning agents such as cleaning agents can also be used to clean grease, oil stains, and dirt. Open the window and let it dry naturally. If the ventilation and sunlight are not good, use a high-quality tissue to wipe it once.