一、針對該鋁板的運輸，一定要嚴禁推拉、抽取等行為，這樣容易造成版面的損傷或是刮傷。盡量將合金鋁板的四邊同時抬起放下，這樣可以使得板材不容易遭受損傷。
1. For the transport of the aluminum plate, it must be strictly forbidden to push, pull, draw and so on, which can easily cause the damage or scratch of the layout. Try to lift the four sides of the aluminum alloy plate at the same time, so that the plate can not be easily damaged.
二、鋁板在置放期間，一定注意不要和明顯化學物品、潮濕性的材料放在一起，這樣容易造成腐蝕的現象產生。
Two. During the placement of the aluminum plate, we must pay attention to not being put together with any chemical or damp material, which can cause corrosion easily.
三、合金鋁板在運輸過程當中，應該選用符合標準的布料將其蓋好，這樣可以避免雨水或是雪霜的侵入，導致產品表面受到不同程度的損傷。
Three, during the transportation process, the aluminum alloy plate should be covered with standard cloth, so that it can avoid the invasion of rain or snow and frost, and cause the surface damage of products to varying degrees.

四、對于合金鋁板廠家的長期置放環境，一定要保持干燥通風、有著明亮無腐蝕的環境條件，這樣才能保持鋁板的性能以及質量。
Four, for the long-term placement of aluminum alloy plate manufacturers, we must keep dry, ventilated, bright and non corrosive environmental conditions, so as to maintain the performance and quality of aluminum plates.
五、針對合金鋁板的置放空間，也需要定期進行清潔打掃，不能讓多余的灰塵、雜物長期附著在鋁板表面。
Five. For the placement of aluminum alloy plate, it is necessary to clean and clean regularly, so that the excess dust and sundries can not be attached to the surface of the aluminum plate for a long time.
六、鋁板廠家在這里提出來一個建議，在置放的時候較好點一些隔離材料，將合金鋁板與地面隔離開來。通常保持在十厘米左右的距離，這樣更能使得鋁板不受到地面的潮濕影響，從而維持質量和性能。
Six, the aluminum plate manufacturer put up a suggestion here that it is best to point out some isolating material when placing it and isolate the aluminum plate from the ground. It is usually kept at a distance of about ten centimeters, so that the aluminum plate will not be affected by the humidity of the ground, thus maintaining the quality and performance.